Operation / Technical Manual
NORM-O-TEMP
®
, Model 111W
Page 30 of 82
ii.
Slide the collar back towards the hose
iii.
Push the female Hansen socket of the hose over a male Hansen plug of
the unit
iv.
Allow the collar to SNAP into place and return to its original position
v.
Gently pull on the connecting hose to assure a positive connection
vi.
Next, push back the collar of a female Hansen socket on the unit with
one hand
vii.
With the other hand, insert the male Hansen plug of the connecting
hose
viii.
Release the collar of the female Hansen socket
ix.
Push the male Hansen plug until it SNAPS into position
x.
Gently pull the connecting hose to assure a positive connection
2.
To attach a blanket/pad to the connecting hose (if necessary):
i.
Insert one end of the blanket/pad to the plastic outlet coupling of the
connecting hose
ii.
Insert the other end of the blanket/pad to the plastic return coupling of
the connecting hose
iii.
Gently pull on the blanket/pad to check that the connection is secure.
I.
Assure that the blanket/pad is laying flat and that the connecting hose to the
unit is not twisted or pinched.
J.
Check that the power switch of the unit is in “O” position (unit is off).
K.
Insert the appropriate power cable. DO NOT BY-PASS GROUND LUG AS
ELECTRICAL HAZARD MAY RESULT.
3-2.2.
Completing a System Test Routine
After arranging the equipment described in Section 3-2.1, complete this System Test
Routine which describes what switches to press and the changes to observe.
ALARM NOTE:
If power is removed from the unit without actuating the power switch
(I/O switch) a power fail alarm is activated and the LED located on the front panel of
the unit flashes. To stop alarm, restore power to the unit and push the SILENCE ALARM
button.
ALARM NOTE:
If at any time the water falls below the minimum level, the LO WATER
LED is activated and the alarm sounds. The unit shuts down and the operator cannot
proceed until this is corrected by filling the reservoir.
