10
| English
2 610 A15 116 • 23.6.09
Direction Indicators
According to the working condition and the requested
accuracy, select the sensitivity with button
7
.
Direct the reception area
4
toward the rotational laser.
Slowly move the laser receiver upward or downward
until the direction indicators
13
or
15
appear on dis-
play
12
and the 3 red LEDs
1
or
3
begin to flash (when
the speaker is activated, an audio signal can be
heard).
Move the laser receiver upward when direction indica-
tor
15
is displayed and the 3 red LEDs
3
flash (with
the speaker volume on, a slow-beat audio signal is
heard).
Move the laser receiver downward when direction
indicator
13
is displayed and the 3 red LEDs
1
flash
(with the speaker volume on, a fast-beat audio signal
is heard).
When the centre of the reception area
4
is reached,
the centre mark
14
is indicated on display
12
and the
3 green LEDs
2
flash (with the speaker volume on, a
continuous audio signal is heard).
Working Advice
The laser receiver is fitted with magnets
6
for easy fas-
tening to excavators and other construction machines.
The provided retaining clamp
20
enables operation
with measuring rods for checking heights and excava-
tion work.
Maschine Mode (see figure B)
Set the excavator shovel or the bulldozer blade to the
height-reference point.
When using with an excavator, the excavator arm
must be plumb and the excavator shovel must be posi-
tioned in such a manner that measuring can easily be
repeated (excavator shovel open to the stop or shovel
base facing the ground). Ensure that the measuring
always takes place from the same position.
Determine the height between rotational laser and
excavation depth (A + B), which results to set-up
height (C).
Undo the laser receiver from the retaining clamp,
switch on and select the desired measuring accuracy.
Fasten the laser receiver plumb to the excavator arm
at set-up height (C), measured from the shovel
tip/shovel base to the centre indicator
22
/centre mark
14
of the laser receiver.
The desired excavation depth is reached when the
laser receiver signals “height reached”.
Afterwards, it is recommended to check the height
measurement.
Measuring-rod mode
Take care that the magnets
6
are firmly attached with
the retaining clamp
20
.
Apply the retaining clamp
20
with the laser receiver to
the measuring rod. The measuring rod is plumb on the
height-reference point.
When the laser receiver signals “height reached”, affix
the retaining clamp to the measuring rod.
Maintenance and Service
Maintenance and Cleaning
Keep the measuring tool clean at all times.
Wipe away debris or contamination with a dry, soft
cloth. Do not use cleaning agents or solvents.
If the measuring tool should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorised after-sales
service centre for Bosch power tools. Do not open the
measuring tool yourself.
After-sales Service and Customer
Assistance
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: [email protected]
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service: +353 (01) 4 66 67 00
Fax: +353 (01) 4 66 68 88
OBJ_BUCH-986-001.book Page 10 Tuesday, June 23, 2009 1:40 PM
