14
FAQ & Troubleshooting
Troubleshooting
Problem Possible
Actions
Motor / Fan Not Running
Controller may be in AUTO Mode (It will not run at
a temperature less than 30°C when in AUTO)
Change to LO to confirm controller is functioning
correctly
Check all connections are secure
Check Power supply is plugged in
Check Power Socket is turned on
Q:
Do I need an electrician to install the ecoFAN™?
A:
If you have an available power point that can be reached then no
electrician is required. If a power point is unavailable then an
electrician will be required to install one.
Q:
Can I wire it directly into the mains power?
A:
No, you must use the supplied power supply and speed controller for the
ecoFAN™ to work correctly. Failure to do so may damage the product.
Q:
Can I duct the ecoFAN™?
A:
Yes the ecoFAN™ can be ducted in either exhaust or inlet mode by
slipping 250mm diameter ducting over the lip of the motor housing and
fixing with tape.
Q:
Can I paint the ecoFAN™?
A:
Yes, standard spray paint can be used to paint the ecoFAN™. No plastic
primer is required, however the surface must be clean before paint
application. Do not get any paint on the motor/fan module. The product
should be disassembled to facilitate easier painting. Instructions on
disassembly can be seen on page 11 of this manual.
Summary of Contents for Edmonds
Page 1: ...Product Manual...
Page 16: ......
