SIGNATURE 2
- Final Checkout -
1.
Be certain that the bypass valve is in Service position and main valve is completely on.
2.
Check electrical supply to be certain the cord is connected to an uninterrupted 115 volt outlet.
3.
Be certain the warranty card is filled out and mailed in.
4.
Leave this manual with the homeowner.
Important Notice - The plumbing system, piping, pressure tank, hot water tanks, softeners, etc. that have been exposed to
iron bearing water may need to be cleaned of the precipitated iron that has been collected in them or iron bleed thru may
be a problem. We suggest all tanks be drained and flushed thoroughly.
Electrical Connection
5
- Electrical Connection -
1.
Connect the power cord and plug power supply into a 115 volt / 60 Hz receptacle.
Note : Do not plug into an outlet controlled by a wall switch or pull chain that could inadvertently be turned off
Electronic Connections
P = Power Supply
B = Powered in Air Replenish Cycle Only
S = Powered in Entire Backwash Cycle
P B S
