CSI LV-019, Service Manual, Page: 4 / 25

Signature 2 Series
pg. 4
Starting Extra Regeneration Cycle
1. To Start Delayed Extra Cycle
Example [ 1 ]
- If Days Remaining Until Next Regeneration does not read ‘1’, press and hold the
Set/Change button for 3 seconds until the display reads ‘1’, or ‘0000’ on metered models.
-
Regeneration cycle will initiate at the next designated regeneration time.
2. To start Immediate Extra Cycle


First complete above step.
- With Days Remaining Until Next Regeneration at ‘1’ or ‘0000’,
- Press and hold the Set/Change button.
- After 3 seconds, the regeneration cycle will begin.
3. To Fast Cycle thru regeneration

First complete above 2 steps.
Note: Fast Cycle is not necessary unless desired to manually step through each cycle step.
- Press and hold the Set/Change button for 3 seconds to advance to the next cycle step.
Softeners Default (min.) Filters Default
(min.)
Step 1 : Backwash 10 Step 1 : Backwash 10
Step 2 : Brine & Rinse 60 Step 2 : Rest 5
Step 3 : Rapid Rinse 10 Step 3 : Rapid Rinse 10
Step 4 : Brine Refill Set for full salting Step 4 : Not Used 0
Nitro Default (min.) Nitro Pro Default
(min.)
Step 1 : Air Release 6 Step 1 : Air Release 6
Step 2 : Backwash 10 *Step 2 : Oxyclean NP Injection 15 sec.
Step 3 : Rest 5 Step 3 : Short Rinse 1
Step 4 : Air Replenish 12 Step 4 : Rest 20
Step 5 : Rapid Rinse 10 Step 5 : Backwash 10
Step 6 : Rest 5
Warning: On NITRO PRO System, if “J”
Program is used, the Oxyclean NP must be
used to avoid any warranty issues. Step 7 : Air Replenish 12
Step 8 : Rapid Rinse 10
Note: Depending upon system pressure
and other factors, it is possible to observe
flow to drain in the rest cycles. *Only if “J” program (Oxyclean NP Option) is
activated.