Crystal Vision
Statesman
SW808 User Manual R1.8
13
22/12/2008
Selecting the reference
The SW808 may be used with either an SDI or an analogue composite reference. The
selection may be made using Statesman provided an RM19 rear connector is used. Select
either SDI or Composite by checking the appropriate box.
When used with an RM20 connector, the reference selection must be made via a switch
on the rear connector itself. Refer to the Installation chapter for more information.
SW808 Routing and Status
GPI control
The SW808 may be controlled via GPI lines connected to the rear of the frame in which
the module is used. GPI control is limited to recalling Presets or Macros. GPI control
cannot be used at the same time as the SW808 Controller panel as both use the same
physical control lines. Please refer to the Installation chapter for more information on
using GPIs.
To enable GPI control, check the GPI Enable box. It is not recommended to enable GPI
control, if GPIs might be active whilst configuring Presets or Macros.
SW808 status
The main (status) Statesman tab can also be used to monitor the router table, switch
synchronisation, GPI Control status, input presence and reference status when changes are
made from any interface.
The reference selection (SDI/Composite) status is only valid when an RM19 rear
connector is used.