Crystal Vision CVT9604E-3010W, User Manual

Page: 3 / 21

Page 3
Safety Precautions

Do not touch live electrical parts.
Electric shock can be avoided. Follow the
recommended practices listed below. Faulty
installation, improper grounding, and incorrect
operation and maintenance of electrical
equipment are always sources of danger.

Do not try to install equipment outdoor, during
strong wind and rain.

Do not install or remove equipment outdoor,
when raining.

Do not try to install or operate any equipment,
during a thunderstorm.

Always ground all electrical equipment and the
work platform.
Prevent accidental electrical shocks. Connect
power source, control cabinets, and work
platform to an approved electrical ground.

Always use the correct cable size.
Sustained overloading will cause cable failure
and result in possible electrical shock or fire
hazard. Work cable should be the same rating
as the factory.

Always keep cables and connectors in good
condition. Improper or worn electrical
connections can cause short circuits and can
increase the chance of an electrical shock. Do
not use worn, damaged, or bare cables.

Always avoid open-circuit voltage.
The added voltages increase the severity of
electric shock hazard.

Always wear insulated gloves while you adjust
equipment.
Electric power should be turned off and
insulated gloves should be worn when making
any equipment adjustment to assure shock
protection.

Always wear protective clothing such as long
sleeve shirts while you are installing or
removing equipment.

Always wear high, snug fitting shoes.

Always wear clean clothes without grease or oil.

Protect neighboring workers from exposure to arc
radiation.

Always wear long trousers or jeans while you are
installing or removing equipment.

Always wear safety helmet or hard head and safety
shoes before work.

Always keep the equipment in dry places.

Always wear safety harnesses/belt while you work
in high places.

Always wear dry clothing and avoid moisture and
water.

Always wear Public Safety Vest, while you work at
night.

Make sure all electrical connections are tight, clean,
and dry.

Make sure that you are well insulated to eliminate
electric static charge.

Always wear dry gloves, rubber-soled shoes, or
stand on a dry board or platform.

Always follow recognized safety standards.

Always wear correct eye, ear, and body protection.

Always have second person on-site, while you work
in dark, poor ventilation, or high places.

Make sure that you are well protected against arc
flashes, mechanical injury, or other mishaps.

Make sure that the polarity of wire is correct before
installing equipment.

Always handle equipment with care.

Do not block the ventilation of equipment.

Do not put the magnetic parts around the equipment.

Do not put the objects on top of the equipment.
Safety Information