Crystal Vision
Using the front control panel
ARC-10MC User Manual R2.8
26
20/11/2009
Rotate shaft encoder to select Vertical Position.
Press F2 to select to change the value.
Rotate shaft encoder to select value (
±
200 lines).
Press ENTER to accept the new value.
Rotate shaft encoder to select Horizontal Size.
Press F2 to select to change the value.
Rotate shaft encoder to select value (
±
200 samples).
Press ENTER to accept the new value.
Rotate shaft encoder to select Vertical Size.
Press F2 to select to change the value.
Rotate shaft encoder to select value (
±
200 lines).
Press ENTER to accept the new value.
Rotate shaft encoder to select Red Gain.
Press F2 to select to change the value.
Rotate shaft encoder to select value (80-120%).
Press ENTER to accept the new value.
Rotate shaft encoder to select Green Gain.
Press F2 to select to change the value.
Rotate shaft encoder to select value (80-120%).
Press ENTER to accept the new value.
Rotate shaft encoder to select Blue Gain.
Press F2 to select to change the value.
Rotate shaft encoder to select value (80-120%).
Press ENTER to accept the new value.
Rotate shaft encoder to select Red Offset.
Press F2 to select to change the value.
Rotate shaft encoder to select value (0
±
20%).
Press ENTER to accept the new value.
Rotate shaft encoder to select Green Offset.
Press F2 to select to change the value.
Rotate shaft encoder to select value (0
±
20%).
Press ENTER to accept the new value.
Rotate shaft encoder to select Blue Offset.
Press F2 to select to change the value.
Rotate shaft encoder to select value (0
±
20%).
Press ENTER to accept the new value.
Note:
At all times the output line rate will follow the input line rate, i.e. 50Hz, 59.94Hz.
Pressing CAL at any time will return the variable to its default value.
If ENTER is not pressed to accept the changed value it will revert to the value last saved.
The size and position controls are only visible when the User Specified control in the ARC menu
has been selected.
