Crystal Vision ARC-10MC, User Manual

Page: 19 / 40

Crystal Vision
Card edge operation
ARC-10MC User Manual R2.8
18
20/11/2009
Menu Comment
Picture crop top
Rotate [SCROLL] to show TopCrop and press ENTER to select.
Rotate [ADJ] shaft encoder to set the amount of top of picture crop in
lines (0-31 lines).
Example:
TopCrop 10
Picture crop bottom
Rotate [SCROLL] to show BotCrop and press ENTER to select.
Rotate [ADJ] shaft encoder to set the amount of bottom of picture crop
in lines (0-31 lines).
Example:
BotCrop 10
Picture crop left
Rotate [SCROLL] to show LftCrop and press ENTER to select.
Rotate [ADJ] shaft encoder to set the amount of left side picture crop
in pixels (0-31 pixels).
Example:
LftCrop 10
Picture crop right
Rotate [SCROLL] to show RhtCrop and press ENTER to select.
Rotate [ADJ] shaft encoder to set the amount of right side of picture
crop in pixels (0-31 pixels).
Example:
RhtCrop 10
Pass Closed caption
Rotate [SCROLL] to show Pss cc and press ENTER to select.
Rotate [ADJ] shaft encoder to set
On, Off, N/A =
not NTSC
Example:
Pss cc On
Wide screen
signalling blanking
Rotate [SCROLL] to show Blnkws and press ENTER to select.
Rotate [ADJ] shaft encoder to set blanking
On, Off
Example:
Blnkws On
Position and Size menu
From the Position and Size top menu press ENTER then SCROLL to access the menu options.
With these controls the user is able to build a custom aspect ratio. Both picture horizontal and
vertical size may be set as well as the position of the image within the screen area to allow
caption or other data insertion.
Menu Comment
Picture horizontal
position adjust Rotate the [SCROLL/ADJ] control to move the picture
horizontally in sample steps.
±
200, N/A
Picture vertical
position adjust Rotate the [SCROLL/ADJ] control to move the picture
vertically in line steps.
±
200, N/A
Picture size
horizontal (width) Rotate the [SCROLL/ADJ] control to adjust the picture width in
2 sample symmetrical steps.
±
200, N/A
.
Picture size
vertical (height) Rotate the [SCROLL/ADJ] control to adjust the picture height in
2 line symmetrical steps.
±
200, N/A
.
Note:
These controls are only active when the User Specified control in the control menu has
been selected. When not selected the display will show N/A.