3
IMPORTANT INFORMATION
CHANGING MEMBRANE
PRE-FILTER INSTALLATION
QUICK-FITTING
Your Countertop Thunder
™
Reverse Osmosis Water Filter
system cartridges must be replaced at regular intervals to
maintain proper performance.
• The filter cartridges have a limited service life.* Use
only factory approved cartridges.
• Changes in taste, odor, and flow of the water being
filtered indicate that cartridges should be replaced.
• Do not use non-Crystal Quest
®
replacement cartridges.
• Do not use non-Crystal Quest
®
parts or modify/tamper
with unit.
*Life of the cartridge varies with water consumption and water condition
1. Remove the water inlet elbow from pre-treatment cartridge by
turning counterclockwise (Fig 2).
2. Thread male end of pre-filter (Fig 1, #9) into pre-treatment cartridge
(Fig 1, #3) and tighten clockwise. You may need to use thread seal
tape.
3. Thread previous elbow (Fig 2, #3). Thread tape may be needed.
4. Turn on water supply and run for 2 minutes prior to first use.
1. Remove security lock from quick fitting (Fig A).
2. Push and hold collect against body while pulling tube out (Fig B).
3. Remove and throw away the used cartridge.
4. Insert the new filter cartridge in the clips.
5. Push the tubing through collet until it seals firmly at bottom of
quick fitting (Fig C).
6. Put the quick fitting security lock back.
7. Turn on water and check for leaks.
8. Flush 4-5 gallons of water through filter before use.
1. Loosen the connector
fitting counterclockwise.
Pull the filter out of the main fold.
2. Wrap the connector fittin g
with thr ead seal tape
and connect it to a ne w
cartridge .
1. Loosen the
connector fitting
counterclockwise.
2. Remove the membrane
housing cap
counterclockwise.
3. Remove the
membrane with
a pincer.
4. Insert the membrane by
carefully pushing the
spigot end into the
socket at the far end of
the housing until
completely sealed.
®
5. Wrap the connector fitting
with thread seal tape and
connect it to a new cartridge.
Fig 2
1
2
3
Fig
C
Fig
B
Fig
A
Quick fitting
security
lock
