Crystal Quest Thunder CQE-CT-00142 Manual Download Page 2

2

INSTALLATION INSTRUCTIONS

CARE AND OPTIMUM USE

TROUBLESHOOTING

Remove red cap. Follow the instructions below to install your countertop system.

1.    Use COLD water only. Do not use on hot water. This may damage the cartridges. 

2.    The contaminants or other substances removed or reduced by this water filter are not 

       necessarily in all users’ area. 

3.    Soak the diverter in a vinegar and water solution once a month. This will clean deposits that 

       form from feed water and help prevent corrosion of internal diverter mechanisms

1.    Low water pressure or no water flow. Very low water temperatures may cause water flow 

     through membrane to slow or stop. Wait for temperature to rise.

2.    High levels of hardness in feed water. A crystallized layer may form around membrane in feed 

       water with high  levels of hardness, causing water to flow improperly. Soak membrane in 

       vinegar and water solution for 2 to 3  hours to clean membrane. Rinse thoroughly before using.

3.    Exhausted filter cartridges. Exhausted cartridges may clog. If steps above do not bring 

       results, filters should be changed.

OPERATING SPECIFICATIONS:

Pressure Range:               45 psi and up

Temperate Range:           40°-85° F (4.4-29.4°C)

Optimum Service Flow:   0.30 gpm at 60 psi

Diverter

Diverter

Gasket

Outside

threads on

faucet

Water Filters

C R Y S TA L   Q U E S T  

®

®

®

1. Remove the aerator from faucet.

2. Determine the need for an adapter. 

    Choose correct adapter as needed.

3. Attach the diverter to the faucet and 

    turn until tight.

Place the water filter in desired

location on the countertop. 

Insert spout into spout

housing and push

it down firmly.

4. Use the large clamp to tighten unit

    hose to the faucet. 

GASKET Adapters

(use size as needed)

OUTSIDE

threads

INSIDE

threads

Aerator

®

®

®

Fig 1

1

2

9

3

6

7

8

4

5

Countertop Thunder® RO Syste m

1-Diverte r

2-Tubing

3-Pre-treatment cartridge (activated cartridge )

4-Auto shut-o ff valve

5-Membrane 

6-Post-tr eatment cartridg e

7-Spou t

8-Drain line/flow  restrictor

9-Pre-filter (optional )

Countertop Thunder® RO System

1-Diverter
2-Tubing
3-Pre-treatment cartridge (activated cartridge)
4-Auto shut-off valve
5-Membrane 
6-Post-treatment cartridge
7-Spout

8-Drain line/flow restrictor
9-Pre-filter (optional)

Summary of Contents for Thunder CQE-CT-00142

Page 1: ...al Quest Countertop Thunder Reverse Osmosis System INSTALLATION AND OPERATION GUIDE ONLINE WARRANTY INFORMATION CrystalQuest com warranty html Copyright 2020 Crystal Quest All rights reserved MADE IN THE USA ...

Page 2: ...usted cartridges may clog If steps above do not bring results filters should be changed OPERATING SPECIFICATIONS Pressure Range 45 psi and up Temperate Range 40 85 F 4 4 29 4 C Optimum Service Flow 0 30 gpm at 60 psi Diverter Diverter Gasket Outside threads on faucet Water Filters C R Y S TA L Q U E S T 1 Remove the aerator from faucet 2 Determine the need for an adapter Choose correct adapter as ...

Page 3: ...e needed 4 Turn on water supply and run for 2 minutes prior to first use 1 Remove security lock from quick fitting Fig A 2 Push and hold collect against body while pulling tube out Fig B 3 Remove and throw away the used cartridge 4 Insert the new filter cartridge in the clips 5 Push the tubing through collet until it seals firmly at bottom of quick fitting Fig C 6 Put the quick fitting security lo...

Page 4: ... allow the exclusion or limitation of implied warranties or incidental or consequential damages therefore the above limitations of exclusions may not apply to you Should service be required during or after the warranty period or should you have any questions regarding how to use your CRYSTAL QUEST Thunder Countertop Reverse Osmosis Water Filter contact our Technical Support Department at service c...

Reviews: