3- 1
Reservoir Removal
1. Turn off hot tank power switch (located near base plate at bottom) (Figure 3-1) and unplug the water
cooler.
CAUTION: WATER IN HOT TANK IS VERY HOT AND CAN CAUSE SEVERE BURNS. ALLOW SUFFI-
CIENT TIME FOR THE HOT WATER TO COOL BEFORE DRAINING (1-2 HOURS).
2. Press the top cover lock and open the POU cover (Figure 3-2). Drain excess water through the fau-
cets.
Note: Water will remain in bottom half of reservoir and the hot tank; to lower the water below the fau-
cet outlet height, tilt cooler forward slightly while depressing the cold faucet handle (Figure 3-3).
3. To drain the hot tank unscrew drain cap and remove red silicone plug at the rear of the cooler (Figure
3-4 and 3-5) and drain water into a pail or container (approx 0.5 gallon or 1.8 L) (Figure 3-6). Reinstall
red silicone plug and drain cap.
Figure 3-2
Figure 3-3
Figure 3-4 Figure 3-5 Figure 3-6
Figure 3-1
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water
Cooler Service Technician only.
Never attempt to service or repair a water cooler while it is plugged into any power supply.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
