CruzPro MaxRp110, Manual

Page: 32 / 48

Page 32
Appendix D - Important Notes and Warnings
1) The front of the MaxRp110 is splash proof. The back is not sealed and
must be protected from water.
2) The nonvolatile memory in the MaxRp110 will retain data for a minimum of
10 years without power.
3) The lines connecting to the +12/24V Battery should be protected from
shorts by placing a 5 amp fuse near the battery side of the connection.
4) If you want an alarm to sound for a particular Data Source:
a) The alarms must be “armed” (i.e. the Bell symbol must be lit).
b) The Data Source value must fall outside the Low or High Alarm limits.
c) Only Data Sources being viewed on the display will activate the alarm:
5) The displayed value will show “----” or “---” if that Data Source cannot be
displayed or modified. For example - while you can change “Display Damping”
on NMEA channels 2A, 2B, 3A and 3B, you cannot change “Display Damping”
on NMEA channels 1A, 1B or 4A, 4B. A “---” or “----” will be also be shown
if the displayed number is larger than will fit on the display (e.g. the four digit
number 1734 will not fit on 3 digit display).
14) Turning Power ON/OFF. Press and hold the
"
key to turn the MaxRp110
display OFF. The clock will keep running. Press and hold the
"
key again to
enable the display . The Time-Of-Day clock will have to be set again if you
turn OFF the power to the MaxVu110 “A” terminal .
7) After settings are changed it can take up to 30 seconds to save the data to
the nonvolatile memory. If power is removed from the MaxRp110 during this
time the changes may not be saved to memory and the older settings will be used
when power is reapplied.
8) Both High and Low alarms for NMEA data can only be set in full units (i.e.
full Feet or full Meters for Depth data, not tenths).
9) When using the
t
and
s
keys to change a value, holding them down will
cause the value to scroll fast after three seconds and very fast after ten seconds.