CruzPro MaxRp110, Manual

Page: 14 / 48

Page 14
value for NMEA2B in one display configuration, then the high alarm value for
NMEA2B
will automatically change for each display configuration where
NMEA2B is displayed.
Setting Display Damping
It is possible to slow down how fast the numbers on the display change by
adding “Display Damping” to NMEA channels 2A, 2B, 3A, and 3B. Filter
values between 0 (No damping) and 250 (Extremely slow response)
are allowed.
Press and hold both the
%
and
" " " " "
keys for ten seconds to enter the Display
Damping Editor (until you hear a long beep). The filter value, display identifier
(1, 2, 3, L or r) and the word “Filt” will be displayed as shown in Figure 12.
Quick press the
&
key to select the desired display identifier (1, 2, 3, L or r).
Press and hold the
%
and
$
keys to change the filter value. Press the
&
key
for 1 second (until the long beep) to accept the new value, save it to memory and
exit the Display Damping Editor mode.
If the selected data source cannot be filtered (such as NMEA4A or NMEA1B)
then “---” will be displayed for the Filter value.
Figure 12 - Display Damping Editor
Setting the Filter Value to “7” for the
Data Source shown on digital display #3