CruzPro MaxDS110, Manual

Page: 16 / 40

Page 16
Turning Alarms ON/OFF
To “arm” the alarms, press and hold the key 1/2 second. The Bell symbol
will be displayed when the alarms are “armed”. To disable the alarms press and
hold the key for 1/2 second. Any press between 1/2 and 2 seconds will
work. A press of less than 1/2 second or longer than 2 seconds will be ignored.
Setting High and Low Alarm Values
To View and/or Set the High Alarm value for any of the three current displays,
press and hold the key for ten seconds (until you hear a long beep). To
View and/or Set the Low Alarm value for any of the displays, press and hold the
key for ten seconds. The alarm value, display identifier (1, 2 or 3) and the
word “HiAL” or “LoAL” will be displayed as shown in Figure 20. Quick press
the key to select the desired display (1, 2, or 3). Press and hold the
or
keys to change the alarm value. Press the key for 1 second (until the long
beep) to accept the new alarm value, save it to memory and exit the Alarm
Editor mode.
To prevent confusion, the High and Low alarm values are unique for each Data
Source (Depth, Speed or Temperature, etc.). For example, if you change the
high alarm value for Depth in one display configuration, then the high alarm value
for Depth will automatically change for each display configuration where Depth
is displayed.
Figure 20 - Alarm Editor
Editing the Hi alarm
for display #3