Cruzbike Sofrider v2 Assembly Instructions - 3/1/2011
Cruzbike Sofrider v2 Assembly page 5 of 11
Step 4:
Connect the AFT and install the pivot clamp
over the fork steerer tube (fig. 13, silver
cylinder). Attach the handlebar.
fig. 13
fig. 14
Make sure the DiaTech ring is installed on the
fork steerer tube as shown in fig. 13. Insert the
inner (slider) tube of the AFT (telescopic front
tube) into the outer tube of the AFT. You may
want to apply some light Teflon lubricant here
(fig. 14). The inner tube of the AFT has
measurement markings, which should face up
when the bike is upright.
Make sure the two pinch bolts of the pivot
clamp are loose (5 mm Allen wrench) and work
the pivot clamp over the end of the steerer (fig.
13). Tap the top of the Extension tube with a
rubber hammer to seat it around the steerer (see
figs. 15-17). Tighten the two pivot clamp bolts
when the pivot clamp is flush with the DiaTech
ring clamp, which is the black ring at the top of
the steerer.
Use a 5mm Allen wrench and attach handlebar
stem to top of steering extension tube, brake
levers toward the front... will fine-adjust cables
and grips later.
fig. 15
fig. 16
fig. 17
