Q U E S T I O N S ?
C A L L U S 8 8 8 - 2 2 6 - 2 7 8 9 O R E M A I L S U P P O R T @ C R U Z B I K E . C O M
C R U Z B I K E S 4 0
A S S E M B LY N O T E S :
C R U Z B I K E S 4 0
F I T N O T E S :
The S40 frame can be assembled without a workstand. When installing components, a
standard bike workstand can be used - just rotate the clamp to hold the front boom.
The frame accepts wheels that are standard 700c disc brake set with 130mm and
100 mm spacing - just reversed - placing the drive wheel up front. The fork spacing is
132.5mm so 135MM hubs can also be used.
The BB shell is standard 68mm English thread. A typical build utilizes a standard road
drivetrain and disc brakes. The bike should be built with components installed and fit to
the rider prior to running cable housing and cables.
Cruzbike sells a rear rack and an under seat rack that are designed to work perfectly
with the S40 frame. If using another rack, use two 15 mm spacers to achieve the proper
width for lower rack stays.
General tips for a good rider fit:
See our website for a detailed fit video. General tips for a good rider fit:
1-At full pedal extension the rider leg should be slightly bent.
2-On the pedal upstroke there should be around 2” of clearance between the top of
the rider’s knee and the handlebar.
3-The rider’s arms should have a natural bend at the elbows.
4-For shorter riders, the boom can be safely cut down 4 inches.
First time rider fit tip:
if this is a rider’s first Cruzbike, the handlebar placement should
allow enough room for him or her to sit straight up off the seat back. Sitting up improves
confidence and balance while learning to ride.
If the handlebar height needs adjustment higher or lower, we have a curved slider option
and different chainstay lengths available at www.cruzbike.com/s40.
