Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, C
A
91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.020320
2 of 3
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
SWRTY-61N
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
DIP SWITCH SETTINGS:
TOYOTA STEERING WHEEL CONTROL DIP SWITCH SETTING:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP: 1 2 3
4
Atoto, Dual, Farenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Blaupunkt, Most off-brand Radios
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF
OFF
ON ON
OFF
OFF
ON ON
OFF
OFF
ON ON
OFF
OFF
OFF OFF
OFF
ON
ON OFF
OFF
ON
ON ON
OFF
ON
OFF ON
OFF
ON
OFF OFF
OFF OFF ON OFF
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most off-brand radios,
check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
DIP: 5 6 7 8
Toyota
OFF ON OFF ON
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
SPECIAL NOTE:
On 2013 Toyota Sequoia and Tundra, the parking brake wire (RED wire) is in position#1 on the OEM 28-pin connector. Please
insert the YELLOW/BLACK wire on the SWRTY-61N harness into position#1. For all other models, please insert into position# 15.
Please check that you are inserting the pin into the correct location as it is difficult to remove it again. The locking tab of the pin
should be facing UP when it is inserted into the connector.
For 2013 Sequoia & Tundra
For all other models
Pin#1
Pin#15
SWRTY-61N
28-Pin Connector
(wire view)
NOTE: Insulate the Blue/Yellow wire or the 3.5mm plug if not being used.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
For aftermarket radios that have wires for SWC connections, cut off the 3.5mm plug on the Crux SWC Cable and connect the
SWC wires as follows:
Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.
