11.
Apply tape to the connections.
12.
Plug the factory connectors back into the radio and
temporarily place radio back into the dash for
testing.
13.
Install the camera behind the vehicle. Run the
camera extension cable towards the radio and
plug it into the Yellow RCA of the RVCMZ-72D
harness.
15. If the back up camera image does not show on
the screen when the gear is shifted to reverse,
reboot the Connect System. Press and hold the
NAV and MUTE buttons on the Connect knob
simultaneously for about 10 to 15 seconds.
Once the radio has rebooted, put the gear in
reverse and check if the back up camera image
now shows on the OE screen.
14.
Start the vehicle and test the system by putting the
vehicle in reverse gear. The camera image will be
shown on the OE screen.
16. Reinstall the factory radio and panels.
MAZDA
2014
3
2015
–
2017
3, 6, CX-3, CX-5 MX-5
4/4
rev.111617
