BEFORE YOU START:
-
Set the parking brake before working on the vehicle.
-
Disconnect the negative side of the battery to avoid short circuits during installation.
-
Check that you have all the necessary parts listed on the “Parts Included” section.
-
Verify that you have a secure location to mount the Multimedia / Navigation Interface box and
harness staying clear of any major components or HVAC system.
1.
Remove the factory radio to gain
access to the 22-Pin connector.
2.
Unplug the 22-Pin radio connector.
3. Mate both sides of
the 22-Pin T-harness
to the factory harness and factory radio
side.
4.
Connect the LVDS T-Harness to the back
of the factory display and to the factory
connector.
5.
Connect the 6-Pin Molex connector on
the T-Harness to the CAN Bus Module.
6.
Connect the 4-Pin Molex connector on
the T-Harness to the main interface
module.
Please turn to the next page
to continue.
7.
IMPORTANT!
Before powering up the
main module, set the proper DIP switch
settings.
OFF
2 / 6
rev.042817
continued
