FRONT PANEL FUNCTIONS
GND LIFT SWITCHES:
Isolates balanced outputs' chassis ground, to reduce potential ground loops.
POLARITY/PHASE SWITCHES:
Selects polarity/phase for Balanced Output on XLR connector.
BALANCED OUTS:
Balanced Low-Impedance Out (polarity determined by Phase switch).
HI-Z OUTS
: This unbalanced ¼” jack provides a high impendance output signal to your amplifier, mixing
console, or other effect units.
POST/PRE SWITCHES:
Selects signal source for Hi-Z Out. Pre = pass thru/dry. Post = Tube Pre amp out.
INST/LINE SWITCHES:
Engages a 15dB pad for the HI-Z input.
HI-Z INS
: Unbalanced, high impedance ¼” input is optimized for a variety of input levels.
REAR PANEL FUNCTIONS
AC INPUT/FUSE HOLDER ASSEMBLY:
Use only approved AC IEC Power Cable.
CAUTION!!! Make sure
the voltage selector switch is set to the appropriate voltage: 115 or 230Vac 50/60Hz.
Select
the proper main fuse according to the following table.
Line Voltage
Fuse
115Vac
T2A 250V (SLO BLO) 5x20mm
230Vac
T1A 250V (SLO BLO) 5x20mm
LINE VOLTAGE SELECT SWITCH:
This switch selects 115 or 230 AC Line Voltage.
CAUTION!!! SET TO
THE PROPER LOCAL VOLTAGE!
Damage can occur if this switch is not properly set.
POWER SWITCH:
The Main Power Switch will illuminate when set to ON.
