3
Once the Flexi-Fix
wall plates are
secured to the wall,
place the Riser Rail
brackets over each
of the Flexi-Fix wall
plates and secure by
tightening the grub
screw with the hex
key provided.
DO NOT
OVERTIGHTEN.
WHEN USING ADHESIVE FIXING METHOD
24
LEAVE
HOURS
C
(
)
i
CHECK
LE
VEL
AM182441 / AM182541 /
AM182641
Max Distance = 720mm
Assemble wall plate, alignment guide
and locking nut as shown.
Remove backing from adhesive
pad on alignment guide.
Please refer to Important Adhesive Information at
the front of this leaflet before proceeding
Place assembled wall plate in desired
location and press firmly.
Cut the end of the sachet and apply a
generous amount of adhesive to the
back of the wall plate as shown. (Each
sachet has sufficient adhesive for two
wall plates).
Carefully place the wall plate over the
alignement quide and allow the rotation
of the locking nut to secure the wall plate
in position. DO NOT PRESS IN POSITION!!
Leave the adhesive to set for
24 Hours
Undo locking nut and remove wall plate
leaving the alignment guide stuck to wall
Sufficient adhesive
must be applied to
give a uniform
thickness of
approximately
1.5mm when the
wall plate is
positioned against
the wall.
Before starting
ensure all surfaces
are clean and free
from dirt and soap
residue, particularly if
adhereing to tiled
walls.
SWR 060 R02
TIP!
To ensure the
Riser Rail is vertical,
mark the wall
using one wall
plate and
using a spirit level,
mark the second
plate whilst being
careful not to
exceed the
recommended
centre distances.
Step 3
Place the square nut
into the recess in the
back of the wall
bracket.
Partially insert the
grub screw into the
threaded hole in the
square nut.
Image shown for reference only - grub screw
previously fitted into wall bracket.
