CAB 034 R06
Always wear suitable eye protection when drilling.
If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be used. Always ensure that
the drill hole passes through the central tiled area rather than through the grouted area. To prevent
unnecessary damage to the tile, mask the area around the hole with tape before drilling.
Do not strike the product with hard or sharp objects. Do not place hot objects against the glass surfaces
Do not overload the cabinet. Maximum safe working load is 10kg evenly distributed if mounted on to a
solid wall. If mounted on to a cavity wall reduce the load to 5kg evenly distributed.
Note: The wall plugs supplied are for use on solid walls only. For cavity walls or plasterboard use
specialist fixings that are available from all good DIY stores.
Fixing Instructions
1. Hold the cabinet against the wall in its desired location. Check that the
cabinet is straight and level using a spirit level. Open the doors and
mark the wall through the holes in the back of the cabinet with a pencil
(see Fig 1).
2. Using a 6.5mm masonry drill, drill the holes in the marked positions to
a depth of 35mm and insert the wall plugs into the holes in the wall.
3. Hold the cabinet against the wall and align the holes in the back of the
cabinet with the wall plugs - make sure the pre-drilled door knob
locating holes, on the bottom edge of the doors, are pointing
downwards. Insert the mounting screws through the holes in the back
of the cabinet and screw into the wall plugs.
4. For handles positioned on the front of the cabinet use the face mounting door knobs. Place a plastic
washer over the end of each door knob and insert the end of each door knob into the holes on the
mirrored side of the doors or front face of the drawer units. Secure the door knobs in place using the
door knob screws – DO NOT over-tighten the screws.
5. For handles positioned on the bottom edge of the doors use the edge mounting door knobs. Insert the
screw into the bottom of the handle and screw into the pre-drilled hole of the door frame -DO NOT over-
tighten the screws.
Product Care Advice
To retain the best quality finish, clean product regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners, as these will damage the product.
For details of the other items in the Croydex range please visit our website: www.croydex.com
Croydex Limited, Central Way, Andover, Hants, SP10 5AW, UK
Tel: +44 (0) 1264 365881.
Fax: +44 (0) 1264 356437
E-mail:
Mounting holes
Fig 1
CABINET SHOWN FOR ILLUSTRATION PURPOSES ONLY
