Crown I-Tech I-T4000, Operation Manual

Page: 27 / 52

I-Tech Series Power Amplifiers
Operation Manual page 27
2. Select IQ Systems > IQwic > TCPIQ Utility (Figure 4.8). This launches the TCPIQ Utility
on the master computer.
Figure 4.8 Selecting IQ Systems > IQwic > TCPIQ Utility
2A. The master computer should discover the TCP/IQ products (Figure 4.9). If not, please
re-read Section 4.5.4 on wiring rules and Section 4.5.5 on addressing rules. Also read
Chapter 5, Troubleshooting.
Figure 4.9 Example of Discovered Components
2B. Once TCP/IQ Utility has launched, select a single component and click on Set
Address. In the Set Address window (Figure 4.10), set up a TCP/IQ address—it must be
unique. Then set up the same Subnet mask for all of the components as well as the master
computer. Set the IQ address, and select Send Code.
2C. Close the software. Repeat as necessary.
Figure 4.10 Set Address Window
3. Launch IQwic (Figure 4.11) and run a roll call. If there are problems, please re-read Sec-
tion 4.5.3 on wiring rules and Section 4.5.5 on addressing rules. Also read Chapter 5,
Troubleshooting.
Figure 4.11 Selecting IQ Systems > IQwic
4 Advanced Operation