Crown CT29001HX, Original Instructions Manual

Page: 26 / 152

26
English
• Check if the gap between the planes of the blades 1
and 2 is set up correctly� They should not swing or
close too tightly�
Maintenance of blades (see fig. 12)
• Before starting to work and after completing the
work inspect the blades 1 and 2 carefully� If necessary
sharpen them as described above�
• After completing the work clean the blades 1 and 2
with a stiff brush, then wipe them with a cloth�
• Smear cutting edges of the blades 1 and 2 and
movable components from the oiler 16 (see fig. 12).
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 14 �
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com .
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Li-Ion batteries
The contained Li-Ion batteries are subject to the Danger-
ous Goods Legislation requirements� The user can trans-
port the batteries by road without further requirements�
When being transported by third parties (e�g�: air trans-
port or forwarding agency), special requirements on
packaging and labelling must be observed� For prepa-
ration of the item being shipped, consulting an expert
for hazardous material is required�
Dispatch batteries only when the housing is undam-
aged� Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move around
in the packaging� Please also observe possibly more
detailed national regulations�
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
The manufacturer reserves the possibility to introduce changes.