Crown ct16s, Operation Manual

Page: 11 / 28

Operation Manual
page 11 操作手册
CT16S 16-Channel Amplifier Switcher
CT16S
16通道主备功放切换器
2 Setup
(continued)
2
安装
（接上一页）
2.7 Connecting to AC Mains
Connect your amplifier switcher to the AC mains power source (power outlet) with the supplied AC power cordset. First,
connect the IEC end of the cordset to the IEC connector on the amplifier switcher; then, plug the other end of the cord set
to the AC mains.
WARNING: The third prong of this connector (ground) is an important safety feature. Do not attempt to disable this
ground connection by using an adapter or other methods.
2.8 Setting an IP Address for the Amplifier Switcher
To use the CT16S amplifier switcher in a paging delivery system, you need to set a specific static IP address or assign
a dynamic IP address through DHCP for it. If this unit is used in a PDX system, you can use the PDX System Control
application to set the IP address. Or, you can use a deployment tool, NetBurner IPSetup, to make the network configura-
tion. For more information about NetBurner IPSetup, go to the NetBurner Software web site: http://www.netburner.com/
products/netburner_software.html
2.9 Management Software
The management software system is needed to monitor, control, and report all operations that CT16S performs in the
system. Configuring the CT16S can only occur with the management software. For details about the software package,
please consultant your Harman distributor or representative.
2.7 连接交流电源
采用功放原装的交流电线组件，将您的主备功放切换器连接到交流电源上（电源插座）。首
先，将电线组件的IEC端连接到主备功放切换器的IEC接口上，然后，将电线组件的另一端插入
电源插座。
警告：此接口的第三个插脚（接地端）在安全性上起着至关重要的作用。切忌试图使用其它适
配器禁用此接地连接。
2.8 设定主备功放切换器的IP地址
当在公共广播传呼系统中使用CT16S主备功放切换器时，您需要给主备功放切换器分配一个静
态IP地址或是通过DHCP来分配动态地址。如果此单元用于一套PDX系统，您可以使用PDX系统控
制应用程序来设置IP地址。否则您可以使用配置工具NetBurner IPSetup来完成网络设置。如
需了解更多有关NetBurner IPSetup的内容，请浏览NetBurner Software网页：http://www.
netburner.com/products/netburner_software.html
2.9 管理软件
所有CT16S在公共广播系统中的操作需要管理软件监控、控制和记录。只能使用管理软件中配
置CT16S。有关软件包的详细信息，请咨询您当地的经销商或销售代表。