Crowcon I-Test, User'S Operation Manual

Page: 94 / 125

94
4.3 Inlet setup
This functionality allows the user to select a specific predefined cylinder profile to be allocated to the
gas inlet that will be used during normal operation of the I-Test,
A cylinder profile can only created with the Manage Cylinders function in I-Test Manager (see page
25
) but once uploaded to I-Test, a specific cylinder profile can be assigned to an inlet.
Before a gas monitor can be tested the predefined cylinder must be configured to be assigned to the
inlet and have parameters defined such as actual gas value, Lot number and expiry date.
To fully define cylinder proceed as follows:
X
Access the Main menu (see
page 93
).
X
From the Main menu use the arrow keys to highlight the inlet setup icon
À
.
X
Press the
OK
key. The Inlet Function screen
Á
will be displayed.
X
Use the arrow keys to highlight the required inlet to set up  and press
OK
. The Inlet Setup
screen will be displayed
Ã
.
Figure 75: Inlet setup functions
X
The following options are available:
• This function allows the cylinder profile to be selected from a list of predefined
cylinders uploaded via I-Test Manager (see page 95 )
• This function enables the user to enter the actual concentration of the gas in the
physical cylinder to be connected to I-Test. This should be read from the label on the
cylinder (see page 96 )
• This function enables the user to enter the Lot number of the physical cylinder to be
connected to I-Test. This should be read from the label on the cylinder (see page 97 )
• This function enables the user to enter to enter expiry date of the physical cylinder to
be connected to I-Test. This should be read from the label on the cylinder (see page 98 )
À
Á
Ã
OK
OK
13 May 2013 11:30:45 13 May 2013 11:30:45 13 May 2013 11:30:54
I-Test
I-Test
I-Test
Â
Contents
Exit
Unpacking
Set-up
Operating I-Test
I-Test
Manager
Configuring
I-Test
Warranty
Overview
Contacts
Appendices
Troubleshooting
Specification