Programming Smart Remotes to Smart Receiver
The Smart Remote receiver can enroll up to 25 x 4 channel remote controls.
1.
Press and hold the program button PROG on the receiver for one second; LED on.
2.
Press button 1 to learn
(You must learn the remote in by pressing button 1 or
the receiver will not function correctly).
LED flashes 3 times and stays on for 4s
then off. Done.
3.
To enroll more remote controls into the receiver repeat process.
Disabling the Remotes
Change the User-10 Code (2323) PIN # to which the Remote is enrolled with.
Delete all Remotes
Press and hold program button PROG on the receiver for 5 seconds till LED turns off. LED
flashes 10 times. Done.
Delete a single Remote
1.
Press and hold program button PROG on the receiver for 1 second; LED on.
2.
Press Button 1 and Button 2 simultaneously; LED flashes 5 times and off. Successfully
deleting the next registered Remote.
Button Operation
Button 1
:
Press 0.5 second = Away; press 3 seconds = Stay
Button 2
:
Disarm from Away, Stay and Panic
Button 3
:
Relay 1 – momentary
Button 4
:
Relay 2 – momentary
Button 1&2
:
Press for 3 seconds = panic
The Smart Remote receiver has two on board relays that can be used to operate garage
door or control other switchable devices.
Relay 1 can be programmed for momentary, Latching or delay operation.
When enrolling remotes into receiver, press button 2 to learn for latching operation.
When enrolling remotes into receiver, press button 3 to learn for 15s delay operation.
