INSTALLATION
Remember to turn off the mains water supply before connecting to any
existing pipe work.
Warning! Please check for any hidden pipes and cables before drilling
holes in the wall.
!
Position the valve onto the wall and mark the position of the fixing lugs (x4). Make
sure the valve is set back from the front face of the wall by the appropriate depth
to allow for plasterboard, filling and tiling etc. (min. 78mm to max. 105mm see
dimension page).
Mount casting to the wall using suitable fixings.
Always leave access to the four front cartridges for servicing.
Once the valve has been secured to the wall, the black Plastic Dust Cover can be
temporally attached to the valve with the screws supplied. This will protect the valve
while the rest of the work is completed
(see fig 1)
.
Remove Hot and Cold check valves, and flush out the installation, clean the filters
and refit.
Apply a narrow bead of clear silicone sealant around the back edge of the cover plate
and carefully press into position.
Fit the control knobs by lining up the flat surface of the valve cover with the grub
screw on the handle, tighten the screw with the supplied hexagonal key
(see fig 2)
.
Do not use tapered threaded adaptors or excessive thickness
of
sealing
tape
as
this
may
damage
the
valve
body
and
result
in
a
concealed
leak
within
the
wall
cavity
.
Blank
off
and
seal
the
open
outlet
if
it
is
not
required
.
Remove
the
Plastic
Dust
Cover.
Turn
on
supplies
and
test
all
connections
for
water
tightness.
!