Installation of ceramic toilet
Angle valve
Precaution before installing
Minimum static working water pressure:
0.18MPa (5.81Gal(22.0L)/min), failure to
meet this pressure will not achieve the best
flushing function.
Remark: Apply the methods below if you
don’t have
a
water pressure testing device.
Hose
Water storage
barrel
Open the angle valve to check the water
volume. If the water volume
after
10
s
econds
is
greater than
0.97gal
(3.7L), then
it is OK to proceed installation.
Draw drain outlet centerline on the floor
Install
angle valve at
proper
position on
wall according to
dimension of
toilet.
1. Installation of angle valve
Line
Drain outlet
angle valve
2. Hose
Connect the water inlet and angle valve of the
toilet with the matching hose and tighten it
Nut
Bolt
3. Mounting bracket installation
Assemble the mounting bracket with bolts
and then install them to the pre-installed
flange plate on the ground and lock tight
with nuts.
Mounting bracket
Washer
08
Angle valve connector
Inlet connector
Flexible hose
