4 -
6
After Installation/Adjustment
Flush the toilet two to three times to confirm there is no
water leakage and that the lever mechanism is working
properly.
6) Connect the opposite end of the water supply hose to
the angle stop (See figure 5).
A flexible supply hose is
recommended. Hand tighten only - do not use
plumbers
putty or other sealants. Open the supply valve
and flush
the toilet several times. Check all the
connections for leaks
and periodically afterwards following
the installation.
Figure 5
FLOAT
CUP
LOCK
RING
REFILL TUBE
FILL
VALVE
SHANK
WASHER
FLOAT
CUP
LOCK
RING
REFILL TUBE
FILL
VALVE
SHANK
WASHER
Fill Valve Installation Instruction
Replacement Installation
1) Shut off the water supply. Flush the toilet and
remove any remaining water from the tank.
Remove the old fill valve.
2) Install new fill valve by sliding the threaded
portion of the shaft through the hole in the
bottom of tank.
3) Thread mounting nut onto exposed shaft under
the tank/bowl and tighten nut.
WARNING! Do not over-tighten.
4) Connect the water supply.
FLOAT
CUP
LOCK
RING
FILL
VALVE
Water Level Adjustment
1) Loosen the lock ring (see figure 3)
Pull up the valve and set it to the desired water level, then turn it clockwise until the valve snaps into the locked position.
2) Turn on the water supply.
Figure 1
Figure 2
Figure 3
A
1) Turn off water supply and flush the toilet.
2) Remove the tank lid and place it upside down on a clean surface.
3) Note the orientation of the flush valve for reassembly.
4) Remove the flapper from flush valve by pulling up frame of
flapper one side at a time.
5) With a screw driver to loosen the two screws & metal plates
holding the valve, then remove the flush valve from the tank.
6) Install a new flush valve into the tank.
Flush the toilet several times using side lever to proper operation.
Check for leak
Replacement Installation
Flush Valve Installation Instruction
B
C
