3
Step 4
Step 5
a:
Check the unit is level.
If levelling is required, use
a screwdriver to adjust the
hanging position, as follows:
b:
To lift or lower the unit,
adjust the screw shown.
c:
To move the unit closer or
further from the wall, adjust
the screw shown.
Basin Installation
a:
Attach the tap to the basin
and carefully bed in the waste
using solvent free silicone only.
b:
Carefully apply silicone to
the top edges of the unit.
c:
Carefully position the basin
down onto the unit, ensure it is
centrally positioned and flush
at the back.
Connect the tap and waste.
Apply a bead of silicone to the
join between the basin/unit and
wall, on all 4 sides.
Apply silicon where the basin
overthangs the carcass.
Leave silicone, 24 hours to dry.
DE Basin is
shown as a typical example
Basin waste and tap fittings when over tightened can create stress within the
basin material which may in time cause the failure of the product. Waste fittings
should be carefully bedded in silicone and the back nut hand tightened anaddi-
tional quarter turn using a suitable spanner is sufficient to create the re-
quired watertight seal. Care should also be taken when fitting brassware
to tap platforms in order to prevent similar stress related failures.
a
b
c
a
b
c
Worktop / Basin Installation
a:
Prepare worktop for tap/s
and basin. Cut holes where
required using a suitable sized
hole cutter.
b:
Carefully apply silicone to
the top edges of the unit.
c:
Carefully position the
worktop down onto the unit,
ensure it is centrally positioned
and flush at the back.
Connect the tap and waste.
Apply silicone to the join
between the worktop and wall,
down sides of the unit and
around the base of the basin.
Apply silicon where the basin
overthangs the carcass.
Leave silicone, 24 hours to dry.
Important: All cut edges MUST
be sealed with water proof
sealant or exterior wood varnish.
Step 6
Inserting the drawer:
Place the drawer on the extended slides.
Slightly lift the drawer at the front and then
push fully closed.
Drawer engages automatically!
Test to make sure the drawer operates correctly.
The hook situated on the back of the runner has
to be fixed in the metal side of the drawer.
c
b
a
Glide II Furniture 02/2020