CFQ5.2 top panel
1.
Subwoofer crossover
: use this four position switch to select the correct lowpass crossover points for
your subwoofers : 50 Hz, 80 Hz, 100 Hz, or 120 Hz.
2.
Rear crossover
: use this four position switch to select the correct highpass crossover points for your
rear speakers: 80 Hz, 100 Hz, 150 Hz, or FULL range.
3.
Front crossover
: use this four position switch to select the correct highpass crossover points for your
front speakers: 80 Hz, 100 Hz, 150 Hz, or FULL range.
INSTALLATION
Mounting
Choose the mounting location that best suits your vehicle. Try to maintain ergonomics so that the CFQ5.2
is easy to use while driving. Note that the ISO mount chassis can be mounted into a 1½ factory DIN
location when using a DIN sized after market head unit, flush mounted into an after market dash kit, or be
mounted under a dash.
Factory 1½ DIN Location
Commonly, when mounting into a factory 1½ DIN location, it will be necessary to fabricate custom
brackets to mount the CFQ5.2. Most of these brackets can be made out of sheet metal or 1/8” ABS plastic.
These brackets will connect the source to the equalizer using the screw holes on the sides of both the
CFQ5.2 and source. However, if a dash kit is available for your particular vehicle, Crossfire highly
recommends using one.
After Market Dash Kit
Mounting the CFQ5.2 into a dash kit is fairly easy in most vehicles. Most dash kits contain a bracket
extending back from the backside of the face. These brackets should line up with the bolt holes on the side
of the CFQ5.2. Simply use the screws provided and bolt the brackets to the side panels.
Under Dash Installation
Find a place where the unit can be mounted that is sturdy, yet easy to access. Using the brackets and screws
provided with the CFQ5.2, follow the diagram below.
Please read the remainder of the instruction manual thoroughly before mounting the unit.
WIRING
Wiring for the CFQ5.2 comes in the form of a modular wiring harness. This wiring harness contains four
color-coated wires; red, black, blue and yellow. The colors correspond with the following:
-Red wire is to be connected with a co12 volts
