Crossfire CF125 2013, Operating Instructions Manual

Page: 27 / 59

I
:x_
BASIC MAINTENANCE PROCEDURES
I
BRAKEING SYSTEM Cont.
Hydraulic brakes require brake fluid for its operation. Both front and rear brakes have a brake fluid reservoir
built into the master cylinders. Follow the procedures below to check and fill the cylinders with the specified
brake fluid.
RECOMMENDED BRAKE FLUID - DOT 4
ADDING BRAKE FLUID PROCEDURE (FRONT)
I. Clean all dirt and dust from the master cylinder cap G)
2. Remove the cap screws
O
with s Phillips head
screwdriver.
3. Remove the cap. Be careful not to damage the
diaphragm gasket that is seated under the cap.
4. Add the required amount in to the master cylinder. (DO
NOT OVERFlLL) (Always use fresh fluid sealed bottle)
5. Replace the cap and tighten the screws securely.
6. Squeeze the brake lever to be sure the brakes are
working properly.
7. Check the brake hose and brake caliper for leaks.
ADDING BRAKE FLUID PROCEDURE (REAR)
I. Clean all dirt and dust from the master cylinder cap f)
2. Remove the cap screws
O
with a Phillips head
screwdriver.
3. Remove the cap. Be careful not to damage the
diaphragm gasket that is seated under the cap.
4. Add the required amount in to the master cylinder. (DO
NOT OVERFILL) (Always use fresh fluid sealed bottle)
5. Replace the cap and tighten the screws securely.
6. Press the foot brake lever to be sure the brakes are
working properly.
7. Check the brake hose and brake caliper for leaks.
If you are unsure how to re-assemble a part, contact your Crossfire M otorcycles dealer for servicing
information and/or servicing.
Be very careful not to spill brake fluid on painted
surfaces or it will damage the paint. It will also be
harmful to some rubber parts. Be careful when you
remove the master cylinder cap, make sure the
motorcycle is in an upright position.
34
BASIC MAINTENANCE PROCEDURES
:X. ,
ENGINE OIL Cont.
Allow the engine oil to circulate in the engine for
2 - 3 minutes before riding at start up. This will
give enough time for the oil to lubricate all critical
engine components. Failure to do so, will cause
engine dama�e.
A-
Improper disposal of drained fluids is harmful to
the environment.
CHANGING OIL
If the oil filter and cap are not installed correctly,
it
will cause serious engine damage.
Do Not dispose of drained oil in an appropriate
manner. Most parts stores or auto shops do take
used oil.
I. Start and run the engine at idle for 3-5 minutes, then stop
it.
2. Stand the motorcycle on a straight level surface so that it
is not leaning to either the right or left & support it.
3. Remove the oil filler cap. (Pg. 26)
4. Place the oil drain pan under the engine.
5. Remove the oil drain bolt
O
and sealing washer G).
6. As the oil is draining out, press and hold the engine stop
button and the starter button. The engine will turn but
will not start. This will allow all the oil to be drained from
the engine. {ONLY FOR 5 SECONDS)
7. After the oil has drained, apply fresh engine oil to the
drain bolt threads.
8. Install and tighten the drain bolt with a new sealing
washer to llft lbs. (lSNm)
9. It is recommended to replace the oil after every 15 hours
of riding.
10. Fill the crankcase with the recommended oil only.
11. Install the oil filler cap.
12. Check the oil level by following the steps in "Checking &
Adding Oil".
27