Cross Technologies 2016-75-213, Instruction Manual

Page: 10 / 19

2.2 Rear Panel Input/Output Signals - Figure 2.1 shows the input and output connectors on the rear panel.
AC1 - POWER IN
AC input for switching
power supply.
100-240 ±10% VAC,
47-60 Hz.
J10 - MONITOR AND CONTROL
DB9 female connector. see Table 2.1.
J3 - 10 MHz EXT REF INPUT (Option -E)
10 MHz external reference input, 3 ± 3 dBm, 75
ohms, BNC female connector.
AC
GND
J18
10 MHZ REF
OUTPUT
J10
AND
MONITOR
CONTROL
RF OUT
J4 J5 J3
10 MHZ
IF IN
EXT REF
J5 - RF OUT
250-750 MHz,
0 to -20 dBm output
see Table 2.2.
J4 - IF IN
70 MHz,
-10 to -40 dBm input
see Table 2.2.
DS7
VDC on RF
INPUT
DS7 - SSPB ALARM LED (option -V)
Lights yellow when +24 VDC SSPB
voltage is present on RF OUT, J5,
center pin.
J18 - 10 MHz REF OUTPUT (option -E)
10 MHz reference output. 75 Ω BNC
female connector.
1 5 2 3 4
6 7 8
9
FIGURE 2.1 2016-75-213 Rear Panel I/O ʼ s
TABLE 2.1 J10 Pinouts (RS-232C/422/485*) TABLE 2.1 J10 Pinouts (RS-232C/422/485*)
Pin Function
1 Rx-
2 Rx+ (RS-232C)
3 Tx+ (RS-232C)
4 Tx-
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Open
8 Not Used
9 Alarm Relay: Normally Closed
*Remote Serial Interface
Interface: DB-9 Male
Protocol: RS-232C (RS-232C/422/485
option -Q ), 9600 baud rate, no parity,
8 data bits, 1 start bit, 1 stop bit.
TABLE 2.2 IF/RF Connector Options TABLE 2.2 IF/RF Connector Options TABLE 2.2 IF/RF Connector Options
Option IF RF
STD BNC, 75 Ω Type F, 75 Ω
-B BNC, 75 Ω BNC, 75 Ω
-C BNC, 75 Ω BNC, 50 Ω
-D BNC, 50 Ω BNC, 50 Ω
-N BNC, 75 Ω Type N, 50 Ω
-M BNC, 50 Ω Type N, 50 Ω
-S BNC, 50 Ω SMA, 50 Ω
2016-75-213, Rev. A Manual Page 9 4/16/09
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com