Croplands PEGASUS 4000, Parts & Operators Manual

Page: 17 / 168

2.8
Pegasus BT-POM 1212 - Rev 3
4 Fit the Spray Controller
The Spray Controller has been fitted and
fully tested at the factory but has been
disconnected and packed for transit.
To fit the Spray Controller:
1. Unpack the Spray Controller and
cables.
Connect the leads of the Controller to loom.
2. Connect the leads at the rear of the
Spray Controller (shown connected).
3. Fit the Spray Controller console into
the tractor cab in a convenient and
safe location for the operator.
Lock the Controller couplings together.
Ensure dust caps are fitted to the Controller cable couplings
when disconnected.
4. Connect and lock together the main
loom couplings at the rear
of the tractor.
Connect the main loom couplings.
Dual Line Option
(See page 3.24 for more information)
If you have chosen dual lines to be fitted
to your sprayer, you will be familiar with
the use of this option on your Pegasus
sprayer.
In general terms, there are usually two
reasons to have dual lines fitted:
1. To increase the boom output using
the same speed setting by
introducing a second boom line - this
negates the need to change nozzles
to perform this task, and;
2. To increase the speed range available
for your sprayer by having the
second boom line cut in/out at a
given speed.
For operating instructions for the model
of spray controller you have been
supplied, refer to the controller manual
supplied seperately.
NOTE
MT3405 Controller standard. Dual lines on the boom.
Dual line valves at the rear of the sprayer.
Ensure any colour coded cable-ties on
the looms are matched.
If the ZYNX X20 controller is fitted,
refer to the X20 Instruction manual for
installation guidelines and connection
diagrams.
NOTE
The male plug has locating holes so
it can be mounted on the rear of the
cab. Likewise, if you have an electric/
hydraulic control console for a wing-
lift boom; it is recommended the black
trailer plug also be fixed next to the main
loom connector (see page 2.14).
NOTE
Hook-up
Section 2