CropCare LGX5P, Assembly Manual, Page: 3 / 8

3
Assembly Instructions
Assembly
1.
Unhook the bungee strap from the eye bolt and
remove the tank from the LGX5P sprayer frame
(Figure 1).
2.
Use three carriage bolts, 1/4-20 x 1/2”, grade 5
(a), and three 1/4” flange nuts (b) for attaching
the handle mount and hose holder (c) to the
LGX5P base (d) as seen in (Figure 2).
3.
After the handle mount has been installed place
the five gallon tank back onto the sprayer frame
and secure to the frame by reattaching the
bungee straps to the eye bolt. (Figure 3)
4.
To install the loom clamps (e Figure 2) Route
hoses through the loom clamps (e) before
fastening the loom clamps to the handle
mount (c) (Figures 2 & 4). Mount using two
MR1024*12 (f) and two NNC1024 (g).
5.
Insert filter and hose into tank. Make sure to
push enough hose through the tank lid so the
filter reaches the bottom of the tank. Then
thread the tank lid onto the tank until snug.
(Figure 4)
6.
Attach the spray gun to the frame using the
mounting clips. (Figure 4)
Figure 4: Instaling 5080015PP406X26 spray gun, filter and tank lid Figure 3: Reattach 5 gallon tank
Figure 2: Installing handle mount and handle Figure 1: Removing the tank
Loom clamps
Filter