Cron TP26G+, User Manual, Page: 17 / 31

6.4.2 Slip Paper Collector connec on
6.4 Slip Paper Collector
6.4.1 Slip Paper Collector structure
6.4.3 Slip Paper Collector unit maintenance
6.5.3 Using the Straight In-line Bridge
6.5.4 Straight In-line Bridge maintenance
6.5 Straight In-line Bridge
6.5.2 Straight In-line Bridge connec on
6.5.1 Straight In-line Bridge structure
Air outlet
(nozzles)
Slip paper rollers
Power control cable connec on
Fans
1
6
2
3
4
5
1
6
2
3
4
5
Chapter 6: Op onal Devices
The Slip Paper Collector is an op onal device used to separate slip papers on the H model CTP device, remove
and organize slip papers effec vely, increase the number of single delivery, and reduce the manual interven on on
slip paper handlings.
A ach the Slip Paper Collector unit under the slip paper outlet path according to the screw holes posi on
provided, then connect the power control cable to the port shown below,
a) Regularly clean the air outlet nozzles
b) Regularly check the condi ons & cleanliness of the slip paper rollers
c) Regularly check the transmission gears lubricants& condi ons
d) Regularly check the fans opera on
The Straight In-line Bridge is op onal peripheral, a aches to the host CTP device for transpor ng the CTP
exposed plate output to the processor unit, or it can be a temporary single plate stacker.
a) Note: when ordering the Straight In-line Bridge to be bundled with the
host CTP device, reserved BGP connector port will be replaced with cable
connec on port for Straight In-line Bridge connector.
b) USB port connec on for host CTP device TP26 / TP36 / TP46 / TP60
models can be located on the same connec vity panel as shown in below;
c) For TP72CTP device, the Straight In-line Bridge connector is located
lower le underneath where the bridge installed.
a) Plate Stoppers is closed (flat): bridge is in full working mode. Plate will be transported through the bridge into
the processor unit;
b) Plate Stoppers is opened (flip up): convert bridge become atemporary single plate stacker.
a) Regularly clean the conveyor belt, conveying the upper plane
b) Regularly check bridge level(height) and posi on against CTP & processor
c) Regularly check the working mode is valid.
Conveyor belts
Plate stoppers
Bridge connec on cable port
TP72cable connec on port
Bridge installa on bracket
Bridge support arms
33
32
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR SIMPLE AND DIRECT
丨
STEADY
丨
MAJOR