Cron TP26G+, User Manual, Page: 11 / 31

Chapter 5: Opera on Instruc ons
5.1 Turning on device
Refer to 4.6.7, connect the computer USB port
5 . 3 Laboo-HDI installa on & startup
5.3.1 Connec ng the Dongle and install LaBoo5.1.*so ware
5.3.2 Verify and making sure CTP device driver is installed correctly
5.2 Connec ng to computer
b)
a) Using the cam switch, Then turn the cam switch to the ON posi on to allow power supply access to the device.
b)Using miniature circuit breakers, switch the circuit breaker up to the ON posi on for power supplies to the
device (right figure is a 3-phase power circuit breaker).
a) Remove the supplied dongle from the LaBooso ware box and plug it into the USB port of the computer;
b) Inserts theLaBoo so ware installa on disk(provided in the LaBoo so ware box) and insert it into your
computer's CD-ROM drive and run the "HDI Setup.exe" file;
c) Follows the so ware installa on steps to install the LaBooso ware and dongle driver.A er installa on is
completed successfully, the computer desktop will have the following icon shown as below:
a) Under Windows Control Panel - Device Manager, confirmed that the CTP device driver has been
properly installed. The following hardware “CRON laser device, V1C” can be found under the Universal
Serial Bus controller.
b) If so ware installa on incorrect, the so ware will not be able to establish connec on to the device. In
this case, you need to manually install the CTP device driver by upda ng with newer driver for the
Windows. Device driver files are stored in the LaBooso ware root directory - "USBDrv128B" folder, please
manually update un l the device driver is installed and shown in the Device Manager under the Universal
Serial Bus controller.
c) a)
21 20
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR
SIMPLE AND DIRECT 丨 STEADY 丨 MAJOR