Visit us at
crlaurence.com
for international toll free information 4
A
C.R. LAURENCE CO., INC.
Installing the Side Grip
For your own safety, always use the side grip.
Install it by screwing it firmly on the grip holder.
The side grip can be pivoted for easy
operation. See the figure at right.
Installing or Removing the
Abrasive Belt
CAUTION
:
Always be sure that the tool is switched off and
unplugged before installing or removing the belt.
Loop the belt over the front pulley. Hold the tool
as shown at right and press down to retract the
front pulley so that you can slip the other end of
the belt over the rear pulley. When pressing down
the tool, be careful not to allow the front pulley to
turn unexpectedly, causing you to lose control of
the tool.
ASSEMBLY
Switch Action
CAUTION
:
Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to
the "OFF" position when released. If it does not
operate properly, do not use the tool. Have it
repaired immediately.
To start the tool, simply pull the trigger. Release
the trigger to stop. For continuous operation, pull
the trigger and then push in the lock button. To
stop the tool from the locked position, pull the
trigger fully, then release it.
Speed Adjusting Dial
The belt running speed can be adjusted and
maintained between 200 m (656 ft.) and 1,000 m
(3,280 ft.) per minute by turning the adjusting dial.
The dial is marked 1 (lowest speed) to 6
(full speed).
CAUTION
:
Adjust the speed adjusting dial only within the range of numbers 1 through 6. Do not force the dial
beyond this range or damage to the tool may result.
Side Grip Can Pivot
Grip Holder
Side Grip
Rear Pulley
Front Pulley
Lock Button
Switch Trigger
Speed Adjusting Dial
