CRL 64” BELT SANDER
MODEL BM64B FOR 102 x 1625mm SANDING BELTS
crlaurence.com
●
Toll Free (800) 421-6144
●
Fax (800) 262-3299
CALL TOLL FREE ANYWHERE IN THE U.S. AND CANADA
●
ALL PRODUCTS F.O.B. NEAREST WAREHOUSE
6
4.0 MAINTENANCE
●
ALWAYS
Shut off the machine and disconnect (unplug) the power from it's source
before performing any maintenance operation.
4.1 Maintenance Schedule
4.2 Lubrication
The only bearings on the sander that require lubrication are the motor bearings
on certain motors ONLY.
If the motor has a grease fitting for applying lubrication (See Photo 3, page 8) follow intructions below.
Every Six Months.
Apply grease sparingly. Overly greased bearings can create seal failure and eventually cause
bearing failure.
Type of grease:
CRL Cat.No.WL14
No.2 lithium base grease.
Use
CRL Cat.No.1200
Metal Lube on the belt door hinges.
4.3 Recutting / Replacing the Pulleys
After a year or two of continued machine use, the pulleys will wear and need to be replaced or have a new crown
machined in them. This is usually evident when you cannot get the belt to track and pulley adjustment will not
correct the tracking. To check this, lay a straight edge across the pulley. A new pulley will have a noticeable hump
or crown in the middle of it. A worn-out pulley will be flat or even have a valley in its center. If the pulley is worn, a
one degree crown should be remachined into the surface or the pulley should be replaced with a new one.
BM64B Maintenance Schedule
Maintenance Performed
Weekly Monthly 6 Months
Wipe down/clean sander exterior
YES
-
-
Clean out/rinse water tank
YES
-
-
Check electrical cables for wear/abrasions
YES
-
-
Examine belts for breaks or frayed spots
YES
-
-
Check pulleys for alignment and tightness
(see note 4.3)
-
YES
-
Lubricate Motor (not needed / no fittings provided)
-
-
-
Sand and repaint chips in exposed metal parts
-
-
YES
Check machine fasteners/mountings for tightness
-
-
YES
