General Information
CRL has designed this machine specifically for use in glass drilling by industry professionals. You must use the
machine only for the designated purposes. We are not responsible for any accident which may be caused by
misuse. As you begin familiarizing yourself with the machine, pay attention to the following details:
• Do not work on porous surfaces. This unit is designed for glossy surfaces, such as glass.
• Never change the speed of the machine when the diamond drill is in contact with the glass.
• Make sure you are feeding a sufficient amount of water while drilling.
• Watch the condition of the glass when drilling to determine correct drill speed.
• Keep speed and water feed constant until the drill bit is completely removed.
• Do not disassemble the machine. This will void your warranty.
ELECTRICAL REQUIREMENTS
Your AMZ1 Machine has been shipped ready for 110 VAC power. The machine features a heavy-duty supply
cord with grounded 3-prong plug. This machine should always be used on a grounded outlet with built-in
ground fault -circuit protection. If you do not have a G.F.C.I. protected outlet, contact us to purchase our
portable in-line G.F.C.I. device, CRL Cat. No. GF1. This machine should not be used with extension cords.
Plug directly into grounded outlet.
Your AMZ1 Machine features an electronic speed control that will accept 110 or 220 volt input in either 50 or
60 cycle power. To use this machine with a 220 volt circuit, contact a qualified electrician to provide you with a
properly fused and grounded circuit, and to supply connections.
SAFETY
This AMZ1 Machine is suited for use by glass industry professionals. The operator must understand the nature
of glass and observe safe, accepted handling procedures for glass before use. Incorrect and careless use of this
machine will decrease the durability of the product and can cause serious injury. Please read all of the
instructions -thoroughly before use.
When working with the AMZ1 Machine, please note the following precautions:
• Wear appropriate eye, hand and body protection.
• Provide properly grounded G.F.C.I. protected electrical connection.
• Adjust RPM to suit diameter of diamond drill being used.
• Never touch diamond drills while in operation.
• Support glass properly before setting machine on glass.
• Glass must lay horizontal and be stress free.
• Never drill glass in the vertical position.
• Use only designated tools to insert a diamond drill in the chuck.
• Unplug machine when changing diamond drills.
• Block small pieces of glass securely.
• Do not use on tempered or wired glass.
• Keep the control box and motor dry at all times.
