11
12
Visor Replacement
If the pre-mounted visor ( 5 ) is damaged or severely
scratched, you can exchange it with the replacement
visor.
Removal of the Visor
- Slide the visor into the highest position (fully
opened) ( see Fig. I ).
- Pull the red visor-locking lever and remove the vi-
sor ( see Fig. J ).
Inserting the Visor
- Place the replacement helmet on the hold-down
device and observe the correct positioning in the
process (fully opened) ( see Fig. I ).
- Pull the red visor-locking level and place the visor
appropriately ( see Fig. J ).
- Allow the replacement visor to snap in and close
the visor.
I
J
Selecting the correct helmet size
- Choose your helmet by measuring the circumfer-
ence of your head with a flexible tape measure.
Always try on a couple of different sizes before
buying a close fitting helmet. When wearing the
helmet, the skin of your temples should ideally
move with it.
- Make sure that the helmet does not move around
when the retention system is open.
- The retention system must be set securely. The
chinstrap must sit comfortably under the chin as far
back towards the neck as possible. Fasten it as tight
as possible. The right degree of tension is reached
once you find it difficult to insert your finger be-
tween the chinstrap and neck, yet finding it easy to
breath and swallow. Make sure that the helmet sits
securely once the retention system is on. Make sure
that the helmet does not restrict your movements,
e.g. when turning your head to look behind you.
- Make sure the helmet carries a sticker certifying ho-
mologation.
Maintenance and Care
Regular maintenance and care contributes to safety and maintaining the helmet.
Cleaning of the Helmet
- Never use solvents, petrol or other detergents when cleaning the shell and interior of your
helmet.
- Only use water and pH balanced soap.
Visor care and cleaning
- After using the helmet, with a soft cloth, lightly wipe off any grime (e.g. dead insects, dirt,
sand, dust etc.) from the visor and then fully wipe it clean using a dry soft cloth.
- When the visor gets wet (e.g. rainwater) it should always be wiped with a soft cloth.
- When cleaning the visor, never use any petroleum-based solvents or detergents containing
abrasives.
Cleaning of the Cheek Pads, Acoustic Pads and Inside Pads
- Hand wash below 30 °C.
- Allow to dry at room temperature.
- Avoid sources of heat.
- When not in use, store in a dry, well ventilated place.
Size table
Size
Head
circumference
L
59 – 60 cm
XL
61 cm