© 2021 All rights reserved. Data subject to change without notice.
23
Rev. E | 2021.03
LPT - Operation Manual
6.6.2 Enclosure Bottom
NUMBER
FEATURE
Œ
Door Hinge
•
Conduit Entry
6.7 Wiring Connections
The LPT analog transmitter is a low voltage powered device. Any application of operating voltages
higher than indic
ated in the specifi cation may result in damage. Double check wiring connections
prior to powering the transmitter. Damage from incorrect wiring connections or from too much
voltage applied is not covered under warranty.
All wiring should be run in EMT (or better) conduit properly earth grounded. Signal output and
supply should be in shielded cable. The cable shield should be connected to earth ground at the
controller/power supply that is providing power for the LPT.
NOTE:
Be careful when knocking out the conduit entry. Fully open the enclosure door so the circuit
board is safely away from the conduit entry area so you do not risk damaging it.
Œ
•
