Powering up the Device without the GSM connector secured may result in product
failure.
6. Plug in supplied wire harness to Device. Ground/Black wire should be on far left side
of Device matching to (Ground) on Device front panel. Match Power/Red wire to VIN
(Voltage IN) on Device.
7. Make sure the vehicle is parked outside and has a clear view of the horizon for GPS to
“lock in”.
8. Observe LED status to confirm proper installation and if device is receiving GPS/GSM
signals
PWR = this LED will move to a solid RED state as soon as the device receives constant
power
USR2 = GPS signal. When the GPS has locked on, this LED will move to a solid RED
state. It may take up to fifteen minutes to lock on, although generally less than five
minutes.
USR1 = GSM /Cellular status. This LED should move to a solid GREEN state within one
minute of the Device being powered up.
