1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
INSTALLATION CAUTIONS & WARNINGS
**FOR SAFETY REASONS, DO NOT INSTALL RS900/901 in vehicles with MANUAL TRANSMISSIONS
.** If
accidentally left in gear, a remote started vehicle could become a self-propelled threat to life and property.
WARNING:
This system does NOT have engine overrev protection. Make certain vehicle throttle linkage operates
properly and does not stick. A stuck throttle will cause severe engine damage
DO NOT
extend the RS-900 Remote start ignition harness length. Mount the module so that main harness reaches all
ignition switch wiring. Extending these wires could result in poor performance.
DO NOT
route any wiring that may become entangled with brake, and gas pedals, steering column, or any other moving
parts in the vehicle.
DO NOT
exceed the rated output current of any circuit on the Remote start module. Failure to observe this warning will
result in damage to the unit.
DO NOT
remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate
ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.
WIRING INSTRUCTIONS
PROGRAM/OVERRIDE SWITCH: 2 PIN PLUG
This switch is used for programming features, transmitters, valet mode, and must be used to override a starter disable (if
optional feature installed) in the event of a non-operating remote control.
LED: 2 PIN PLUG
The LED is only used as a VALET/PROGRAMMING indicator and it will FLASH for use as security deterrent when the
optional ANTI-GRIND/STARTER DISABLE feature is installed. Mount in a visible location on the dash or in the console.
12 PIN PLUG:
PIN 1: YELLOW: (-) IGNITION 1 OUTPUT (FOR ADDING IGNITION RELAYS)
PIN 2: YELLOW/WHITE: (-) ACCESSORY OUTPUT (FOR ADDING ACCESSORY or IGN2 RELAYS)
Use these wires when the vehicle requires a second IGNITION 1, IGNITION 2, or ACCESSORY wire to be activated. This
occurs commonly in Toyota, and late model GM cars. See diagram below on NEXT PAGE.
PIN 3: BLACK: MAIN SYSTEM GROUND
Connect to chassis metal of the vehicle. An existing bolt or screw MAY provide an adequate ground, or drill a small hole,
Summary of Contents for RS-900ER.III
Page 13: ......
