18
OPTION DESCRIPTIONS
10. UNLOCK BEFORE REMOTE START:
This option is used to disarm an OEM Alarm System before Remote Start.
Default = OFF
11. TRANSMISSION TYPE: Requires Tach Wire connected and programmed
This option selects automatic or manual transmission mode
1.
Manual Shift Transmission - Requires Remote Start Button pressed with (-) Hand Brake Activated.
2. Automatic Transmission – Default.
3.
Manual Shift Transmission – Starts Exit procedure with (-) Hand Brake Set and engine running.
4.
Manual Shift Transmission – Same as 3 with auto shut down 2 seconds after closing last door.
12. IDLE DOWN RUN TIME:
This feature allows the remote starter to take over operation of a parked vehicle when the ignition key is removed and
you exit the vehicle. The vehicle will remain running for the programmed time or until canceled. The choices are: 10,
20, 30 minutes or Infinity Run.
Default = 20 minutes.
13. HORN CHIRP with LOCK and UNLOCK - 1 or 2 Button Press
This option allows the system to chirp the vehicle horn for Lock/Unlock confirmation on 1 button press or a 2
nd
press within 3
seconds. The horn output must be connected to use this feature.
Default = 2 Press.
14. UNLOCK With TRUNK POP:
This option controls whether the system will provide an Unlock / Disarm pulse when the Trunk release is activated from the remote
control. This may be required to prevent unnecessary triggering of a factory alarm on some vehicles.
Default = OFF.
15. PARK LIGHTS ON 30 SECONDS with UNLOCK:
Keeps parking lights on with remote unlock to assist in locating and providing illumination near your vehicle when
approaching at night for safety. The parking light also turns off with ignition on.
Default = ON.
16. HORN PULSE DURATION:
This option allows adjustment the “CHIRP” pulse duration of the car horns. The choices are 15, 20 or 40 milliseconds.
17 OEM Interface (LC-00 Add on Model):
1 Pulse or 3 Pulse Start
Green Wire (-) Start Activation Selection –
Default = 1 Pulse
1 Pulse Start -
When using an Aftermarket Alarm or Keyless Entry System, leave the setting as “1 Pulse” and
connect the Green wire to the (-) Auxiliary remote output wire of the Alarm or Keyless Entry System.
