USING THE REMOTE TRANSMITTER
The transmitter supplied with the EZ-90 system has
six buttons. The button configuration of the EZ-90 is
Factory-set and unchangeable. The EZ-91 model
does not include remote transmitters, as it is
designed for the expansion of a “parent” remote
keyless or alarm system. See Page 11 for
additional information on how to use your remote to
operate a second vehicle equipped with an EZ-90
system.
#3
#1
#2
#4
LOCK
TRUNK
REMOTE
UNLOCK
VEHICLE 2
FLASHLIGHT
START
#4
#6
NOTE: BUTTON #4 Remote Start
There is a deliberate delay built into the system on
button #4 to help prevent accidental remote starting
from the remote being in your pocket or purse.
During normal use, press button #4 for at least 1
second to trigger a remote start.
REMOTE ENGINE CONTROL
REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press the remote start button for at least 1 second. (For EZ-91 models, activate Green Start input wire.)
2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on.
3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.
5) Engine will remain running for programmed run time until reset it is reset with Brake pedal.
AFTER
IGN
4
STARTER
THEN
FLASH 1X
SOLID
SOLID
SEC.
3
