REMOTE ENGINE CONTROL
The system has three remote modes of controlling the engine:
•
Remote starting the engine , Turning off a remote started engine, and Idle Down/Infinity Run modes
REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press Remote Start button.
2) Parking lights flash once, then turn on solid, Ignition/Acc On.
3) After 6 seconds Starter Motor engages, Parking lights and Acc circuits turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.
5) Engine will remain running for programmed run time until reset with Brake pedal or turned off with remote
transmitter.
REMOTE ENGINE STARTING - UNSUCCESSFUL START:
In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then
attempts to restart the engine a 2
nd
and 3
rd
time. For hard starting engines, the unit will allow a starter crank time of
up to13 seconds maximum. This should provide ample cranking time for difficult starts, but is limited to 13 seconds
to help prevent damage to the starter from over cranking in the case of a malfunctioning unit.
1) If engine starts on 2
nd
or 3
rd
attempt, see steps 4 & 5 above of "Successful Start".
2) If Third attempt fails to start engine, the system will turn off and doors will remain locked.
NO FURTHER
ATTEMPTS WILL BE MADE AUTOMATICALLY
TURNING OFF A REMOTE STARTED ENGINE:
1) Engine is running in Remote Start (Parking lights ON).
2) Press Remote Start button.
3) Engine turns & parking lights OFF, Doors remain locked or will re-lock/re-arm if applicable.
AFTER
IGN
6
STARTER
THEN
START
FLASH 1X
SOLID
SOLID
SEC.
Summary of Contents for CoolStart RS-901
Page 9: ...RS900I OP REVA...
