RS-830/810 TRANSMITTER CODE LEARNING
Transmitter Code Learning:
Notes: Remote Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes,
ALL your system’s remote codes must be learned at time of programming!! These systems allow storage of up to 4
different remote codes in memory. Antenna / Receiver must be plugged into unit.
1. Open hood (ground the Gray hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Do not start vehicle)
3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. RS-830: Press Button #1 (Lock) of the transmitter to be learned. RS-810 Model: Press Engine Start button. You
should get 2 light flashes indicating the code-learn. Now the unit is waiting for a 2
nd
code, so repeat this step as
needed with up to 3 additional remotes. The unit will flash the lights in succession after each code learned for up to 4
codes. (2 flashes for the 2
nd
code, 3 flashes for the 3
rd
code etc.) If all 4 codes are learned, the unit will automatically
exit code learning mode, otherwise turn key OFF and close the hood. (See Diagram Below)
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
(GRAY WIRE GROUNDED)
RS-830
IGN
OFF
PRESS
PRESS
LOCK BUTTON
RS-810
COMPLETE
START BUTTON
16
